Schneider Electric EVlink Home Smart
12 fault codes documented
Blinking Green LED (10s) — Charger connected
The charger's LED blinks green every 10 seconds, indicating that it is connected. This is a normal operational status.
Blinking Green LED — Firmware upgrade in progress
The charger's LED blinks green, indicating that a firmware upgrade is currently being performed. Do not interrupt this process.
Connector plugged in but not charging — Connection issue
The charger is connected to the EV, but charging has not started. This usually means the connection is not fully secure or the charging sequence is incorrect.
Constant LED — Pairing status for Anti-tripping device
The charger's LED is constantly lit, indicating it is in the pairing status for an anti-tripping device. This is a normal state during specific setup procedures.
Constant Red LED — Fault detected
The charger's LED is solid red, indicating a fault that requires troubleshooting. This may prevent charging.
Fast Blinking Green LED — Charging suspended
The charger's LED blinks green rapidly, indicating that charging has been temporarily suspended. This could be due to a temporary condition or user intervention.
LED off — No power supply or charger damage
The charger's LED indicator is off, meaning it is not receiving power. This could be due to a power supply issue or damage to the charger itself.
Pulsing Blue LED — Charging cable connected to EV
The charger's LED indicator changes to pulsing blue after the charging cable is plugged into the electric vehicle. This indicates the EV is ready to charge or is in the process of connecting.
Pulsing Green LED — Charge complete
The charger's LED pulses green, indicating that the charging process is complete. This state is typically shown when the charge current is very low for a sustained period.
Slow Pulsing Green LED — Not connected to the internet
The charger's LED pulses green slowly, indicating it is not connected to the internet. This can affect remote monitoring and control features.
Slow Pulsing Green LED — Waiting to connect to internet router
The LED pulses green slowly, indicating the charging station is waiting to connect to the internet router. This is often seen after a restart or power cycle.
Solid Green LED — Successfully connected to the internet
The charger's LED is solid green, confirming that the EVlink Home Smart is successfully connected to the internet for remote operation.