1. and 2.5.0 alternately or F12/F13 and flashing light — Water inlet fault

What does Water inlet fault mean?

The dishwasher stops shortly after starting or during a program, an alarm tone sounds, and the water inlet/drainage indicator light flashes. The display shows '1.' and '2.5.0' alternately, or 'F12' or 'F13'. This indicates an issue with the water inlet.

• The stopcock (water supply valve) is closed or not fully open.
• The water inlet is restricted.
• The filter in the water inlet is dirty.
• Water connection pressure is lower than 50 kPa.
• On-site water drainage connection is too low and needs venting.

Click steps to track your progress.

1. 1

   Before attempting to fix, switch the dishwasher off using the power button.

2. 2

   Open the stopcock (water supply valve) fully.

3. 3

   Clean the filter in the water inlet according to the 'Cleaning and care' section of the manual.

4. 4

   If the problem persists, ensure the on-site connection for water drainage is not too low and vent it if necessary.

5. 5

   If the issue persists, contact a professional to check water connection pressure.