Red bar on display during test - Value too high or too low

What does Red bar mean?

When you are performing a manual test of the Power/Motors components on your Husqvarna Automower, a red bar appearing next to a displayed value indicates that the measurement is outside the approved limits. This can apply to battery voltage, battery current, battery temperature, or the current from a solar cell panel if your model has one. A green bar indicates an approved value.

• Battery voltage, current, or temperature is outside the specified operating range.
• There is an issue with the solar cell panel (if applicable) preventing correct current output.
• An internal fault with a motor or power component is causing abnormal readings.
• Temporary anomaly during the test affecting sensor readings.

Click steps to track your progress.

1. 1

   Note the specific value (e.g., battery voltage, motor current) that is highlighted with the red bar during the test.

2. 2

   Stop the manual test and ensure the Automower's battery is fully charged. Allow it to sit for a few minutes before retesting.

3. 3

   If it's a Solar Hybrid model, inspect the solar cell panel for any obstructions or damage and verify its connections.

4. 4

   Restart the Automower completely, then re-enter the manual test function to see if the red bar reappears.

5. 5

   If the red bar persists for a crucial component, contact your national service organization, providing the details of the test and the specific value indicated as too high or too low.