bit2 - Connection Master Slave — Cannot connect the master board

¿Qué significa bit2 - Connection Master Slave ?

The charging station cannot establish a connection between the master boards.

• Issue with the Ethernet cable connecting the boards
• Faulty connector on the boards

Haga clic en los pasos para seguir su progreso.

1. 1

   Check the Ethernet cable between the two boards.

2. 2

   Try replacing or changing the connector on the boards.

3. 3

   Check communication via the LEDs on the RJ45 connectors.

4. 4

   Check the status LEDs (green/red/blinking) on the board itself.

5. 5

   Re-boot the charging station.

6. 6

   If the fault persists, perform a reset to factory settings on both sides (left then right).