¿Qué provoca el error RUN/ERROR LEDs: 5 flashes/sec RUN, Solid ON ERROR de Carrier?

Startup process aborted. Firmware update in progress or interrupted. Bootloader mode active

¿Cómo se corrige el código de falla RUN/ERROR LEDs: 5 flashes/sec RUN, Solid ON ERROR de Carrier?

1. Allow the boot process to complete. 2. If the controller does not recover, attempt a power cycle. 3. If the issue persists, refer to firmware update procedures or contact support.

RUN/ERROR LEDs: 5 flashes/sec RUN, Solid ON ERROR

Run and Error LEDs flash rapidly — Execution start-up aborted, Boot is running

Carrier · 38AP Air Handler

¿Qué significa RUN/ERROR LEDs: 5 flashes/sec RUN, Solid ON ERROR ?

The controller's startup process has been aborted, and it is currently in the bootloader mode. This may occur after a firmware update or a critical error.

Causas comunes

Startup process aborted
Firmware update in progress or interrupted
Bootloader mode active

Pasos de reparación & Lista de verificación

Haga clic en los pasos para seguir su progreso.

1
Allow the boot process to complete.
2
If the controller does not recover, attempt a power cycle.
3
If the issue persists, refer to firmware update procedures or contact support.

Ver todos los códigos en este manual (60)

Datos técnicos verificados. Última actualización: April 2026

Fallas relacionadas

A051A051 — Circuit A, Compressor 1 Stuck On Failure Alarm A052A052 — Circuit A, Compressor 2 Stuck On Failure Alarm A053A053 — Circuit A, Compressor 3 Stuck On Failure Alarm

Fuente: Carrier 38AP Air Handler

Open Manual (Page 214)Buscar más códigos en este manual