External operating voltage connected for control system

Was bedeutet External operating voltage ?

External operating voltage (1x230V+N+PE) can be connected to the control system via the immersion heater circuit board. Specific terminal connections are required.

• External voltage supply connected to AA1:X11
• Specific wiring changes made on terminal block X2/X9 and X7:24
• Use of a separate earth-fault breaker

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Ensure external operating voltage (1x230V+N+PE) is connected to AA1:X11.

2. 2

   If using a separate earth-fault breaker, disconnect the blue cable from X7:24 and connect it to the enclosed top clamp with the operating zero.

3. 3

   Connect a blue cable (min 0.75 mm²) between the top clamp and X11:N on AA1.

4. 4

   Refer to the illustration for correct terminal connections (AA1:X2 to AA1:X9 if applicable).