Upside down — Mower has been lifted, turned over, or tilt sensor is faulty

Was bedeutet Upside down ?

This message appears if the Automower has been lifted off the ground or has turned over, triggering the tilt sensor. It can also indicate a defective or incorrectly calibrated tilt sensor.

• Automower has been lifted or has turned over.
• Tilt sensor is defective or needs calibration.
• Control box is defective if the fault recurs after calibration.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Correct the mower's position, ensuring it is upright and on the ground.

2. 2

   Check the values for Tilt X and Tilt Y via Tools - Test - Sensors (shortcut 5-2-5).

3. 3

   If any value is higher than 20 or the mower indicates 'Upside down', calibrate the tilt sensor (shortcut 5-6-3).

4. 4

   If the fault recurs within a month after calibration, the control box may be defective and needs replacement.

5. 5

   Contact service if the control box is suspected to be defective.