No remote boundary wire follow — Mower starts mowing instead of following boundary wire to remote area

Was bedeutet No remote boundary wire follow ?

The Automower fails to detect the loop signal strength after reversing out of the charging station, causing it to start mowing immediately instead of following the boundary wire to a remote area.

• Automower does not find the strength on the loop signal that the set corridor width corresponds to.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Try a different corridor width; a greater corridor width usually improves the function.

2. 2

   Check the loop signal strength and compare with Table 8 and Table 9 in the manual.

3. 3

   Adjust the mower's reversing distance.

4. 4

   Inspect the boundary wire for any breaks or interference that might weaken the signal.