CodeRegistry
Marken
  1. Startseite
  2. Carrier
  3. 38AP Air Handler
  4. RUN/ERROR LEDs: 5 flashes/sec RUN, Solid ON ERROR
About·Privacy·Terms

CodeRegistry — Ihre globale Bibliothek für technische Lösungen.

Zu Ihrer Sicherheit: Befolgen Sie immer die offiziellen Herstellerhandbücher. CodeRegistry ist unabhängig und steht in keiner Verbindung zu den genannten Marken.

RUN/ERROR LEDs: 5 flashes/sec RUN, Solid ON ERROR

Run and Error LEDs flash rapidly — Execution start-up aborted, Boot is running

Carrier · 38AP Air Handler

Was bedeutet RUN/ERROR LEDs: 5 flashes/sec RUN, Solid ON ERROR ?

The controller's startup process has been aborted, and it is currently in the bootloader mode. This may occur after a firmware update or a critical error.

Häufige Ursachen

  • Startup process aborted
  • Firmware update in progress or interrupted
  • Bootloader mode active

Reparaturschritte & Checkliste

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

  1. 1

    Allow the boot process to complete.

  2. 2

    If the controller does not recover, attempt a power cycle.

  3. 3

    If the issue persists, refer to firmware update procedures or contact support.

Alle Codes in diesem Handbuch durchsuchen (60)
Verifizierte technische Daten. Zuletzt aktualisiert: April 2026

Verwandte Fehlercodes

A051A051 — Circuit A, Compressor 1 Stuck On Failure AlarmA052A052 — Circuit A, Compressor 2 Stuck On Failure AlarmA053A053 — Circuit A, Compressor 3 Stuck On Failure Alarm
Quelle: Carrier 38AP Air Handler
Open Manual (Page 214)Mehr Codes in diesem Handbuch suchen