Error message displayed — Check connections and cycle ignition

Was bedeutet Error message ?

An error message may appear if the scan tool cannot communicate with the vehicle. This could be due to a loose connection or the vehicle's ignition status.

• OBDII connector is not attached properly.
• Vehicle ignition is not turned on.
• Vehicle computer requires a reset.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Ensure the OBDII connector is securely plugged into the vehicle.

2. 2

   Turn the vehicle's ignition key to the OFF position for 10 seconds, then turn it back ON.

3. 3

   If prompted, select YES to try connecting again.

4. 4

   If the problem persists, refer to the "Error Messages" section in the Troubleshooting guide.