Run and Error LEDs flash in sequence — Controller has been formatted

What does RUN/ERROR LEDs: 2 flashes/sec RUN, 3 flashes/sec ERROR alternating mean?

This indicates that the controller has just been formatted or reset to its factory defaults. Control programs may need to be reloaded.

• Controller has been recently formatted or reset
• Loss of configuration data

Click steps to track your progress.

1. 1

   Verify that the control programs and settings are correctly loaded.

2. 2

   Check if any specific configuration steps are required after formatting.

3. 3

   Consult the system's setup guide for re-configuration.